A new controller no longer inherits the previous one's gyro bias, and a calibration where the pad moved is rejected

The bias reset in sensors_ready only ran when sensor_pad was nonzero, but scan_pads zeroes it on every disconnect,
so a pad connected after another one kept the old pad's bias, and an attempt still collecting finished on the new
pad under the old pad's name. The bias was also loaded only once, at the first StartSixAxisSensor.

- input.c pad_bias_select runs for every pad the sensor code sees: it drops the old bias and attempt, then loads the
  saved bias when gyro_bias_pad names this pad. scan_pads drops them on disconnect. The bias loads with
  gyro_calibration off too, so turning the switch on mid-run applies it.
- The pad identity is the name plus an FNV-1a hash of SDL's serial when the pad reports one, so two pads of one
  model no longer share a bias; the hash keeps the Bluetooth address out of totk.ini and the log.
- An attempt skips 0.5 s of samples (the button press shakes the pad), then averages 1 s. It is rejected when the
  largest per-axis standard deviation exceeds 0.04 rad/s; a steady bias of any size passes. The row then says the
  controller moved (new UI_MENU_GYRO_CALIBRATE_MOVED in all four catalogs) and the bias in effect stays.
- The timeout counts 5 s without a sample, not 5 s from the start.
- Calibrate gyro starts the sensor thread when the game has not yet (title screen) instead of doing nothing.
- Row states are an enum (MOTION_CALIB_*); motion_calibrate_start takes the clock, and only the gamepad's fusion
  instance writes totk.ini, so --probe-services now checks a measured bias, a rejected attempt and the timeout.
- The duplicate copy_name in motion_fusion.c is gone.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
Valiantsin DzerakhandClaude Opus 5.5 committed 2026-11-15 09:32:05 +03:00
1 parent 0a792f22c1
commit 0efa904d90
9 files changed
+267 -182

No files matched your search

+5 -3
View File
@@ -967,12 +967,14 @@ static void tab_controls(float scale) {
char pad[128] = "";
int st = input_motion_calib_state(pad, sizeof pad);
char status[192] = "";
if (st == 1)
if (st == MOTION_CALIB_COLLECTING)
snprintf(status, sizeof status, "%s", menu_text(UI_MENU_GYRO_CALIBRATE_WAIT));
else if (st == 2)
else if (st == MOTION_CALIB_DONE)
snprintf(status, sizeof status, menu_text(UI_MENU_GYRO_CALIBRATED), pad);
else if (st == 3)
else if (st == MOTION_CALIB_FAILED)
snprintf(status, sizeof status, "%s", menu_text(UI_MENU_GYRO_CALIBRATE_FAILED));
else if (st == MOTION_CALIB_MOVED)
snprintf(status, sizeof status, "%s", menu_text(UI_MENU_GYRO_CALIBRATE_MOVED));
if (opt_button("##gyro_calib", UI_MENU_GYRO_CALIBRATE, UI_MENU_GYRO_CALIBRATE_DESC, status))
input_motion_calibrate();
}