mirror of
https://github.com/valentderah/totk-pc-recomp.git
synced 2026-11-18 12:08:38 +00:00
The yaw axis has no gravity reference, so it drifts with the gyro's manufacturing bias. Two controllers of the same model can drift in opposite directions, and the sensor fusion had no way to estimate or remove the offset: aiming with motion turned slowly on its own and needed constant correction. A Calibrate gyro row on the Controls tab collects 250 gyro samples (about a second) while the controller is held still, averages them per axis into a bias, subtracts that bias from every sample before the fusion integrates it, and restarts the angle so the estimate starts clean. Collection has no motion threshold: a controller whose bias exceeds any absolute threshold would otherwise never finish, which is how the first version of this stalled with no way out. Five seconds without the expected samples ends the attempt, from the sample path and from the menu alike, so a sensor thread that stops feeding it is reported instead of leaving the row on "calibrating". The first raw sample and the final bias are logged, so a report carries the numbers that were measured. The row's value says where the controller stands: calibrating, "<controller>, calibrated" once it is done or when the bias was loaded from totk.ini at start, and "calibration failed" when an attempt timed out with no bias in effect. A controller change cancels a calibration that is in progress and clears the bias and the label, so neither is carried over to the new controller. The behaviour sits behind gyro_calibration (the Controls tab's "Gyro bias calibration", default on, live): off, the fusion takes the raw gyro, an attempt in progress is dropped, and nothing is loaded at start, while the saved keys stay in totk.ini so turning it back on restores the last calibration. The bias and the controller's name go to totk.ini when calibration completes, outside the fusion's lock, and are loaded at the next start only when the connected controller has the same name. Tested with a Switch Pro Controller on the 1.4.3 build: the log shows a z-axis bias of 0.139 rad/s (8 degrees per second), calibration finishes in about a second, the yaw drift is gone, and the row reports each state.